PIAGGIO Beverly 125 Service Station Manual page 201

Beverly 125
7. Gasket
8. Spring
9. Tank
CAUTION
ALL THE SEALS AND GASKETS MUST BE REPLACED EVERY TIME THE PUMP IS SERVICED.
Refitting
- Upon refitting, perform the operation but in reverse order.
- Tighten the hydraulic line to the prescribed torque and purge the system.
- When the operation is over, tighten the brake fluid bleed screw to the prescribed torque.
WARNING
BRAKE FLUID IS HYGROSCOPIC; THAT IS, IT ABSORBS MOISTURE FROM THE SURROUND-
ING AIR. IF THE LEVEL OF MOISTURE IN THE FLUID EXCEEDS A GIVEN VALUE, BRAKING WILL
BE INEFFICIENT. THEREFORE, ALWAYS USE FLUID FROM SEALED CONTAINERS. UNDER
NORMAL DRIVING AND CLIMATIC CONDITIONS YOU SHOULD CHANGE THIS FLUID EVERY
TWO YEARS. IF BRAKES ARE USED INTENSELY AND/OR IN HARSH CONDITIONS, CHANGE
THE FLUID MORE FREQUENTLY.
CAUTION
WHEN CARRYING OUT THE OPERATION, BRAKE FLUID MAY LEAK FROM BETWEEN THE
BLEED SCREW AND ITS SEAT ON THE CALLIPER. CAREFULLY DRY THE CALLIPER AND DE-
GREASE THE DISC SHOULD THERE BE BRAKE FLUID ON IT.
Locking torques (N*m)
Oil bleed screw 12 - 16 Hydraulic line fixing screw: 16 ÷ 20 Fixing screws for handlebar control
assembly U-bolts 7 ÷ 10
See also
Front
Rear brake pump - combined
Removal
- Remove the rear handlebar cover.
- Drain the brake system.
- Disconnect the brake fluid line from the pump,
paying attention to a possible escape of remaining
brake fluid.
- Remove the front and rear brake stop button from
the lever.
- Loosen the two retaining screws of the stand and
remove together with the rear view mirror.
- Remove the front brake pump together with the
lever.
See also
Braking system
BRAK SYS - 201