PIAGGIO Beverly 125 Service Station Manual page 98

Engine
- Rotate the engine manually until the belt is slight-
ly taut.
CAUTION
IT IS EXTREMELY IMPORTANT THAT THE BELT IS PER-
FECTLY FREE WHEN THE FIXED DRIVING HALF-PULLEY
IS ASSEMBLED. THIS IS TO AVOID CARRYING OUT A
WRONG TIGHTENING OF THE DRIVING HALF-PULLEY.
Specific tooling
020368Y driving pulley lock wrench
Locking torques (N*m)
Drive pulley nut
75 ÷ 83
Refitting the transmission cover
- Check the presence of the 2 centring dowels and
the correct installation of the sealing gasket for the
oil sump on the transmission cover.
- Replace the cover tightening the 10 screws at the
specified torque.
- Refit the oil loading cap/bar.
- refit the steel washer and the driven pulley nut.
- Tighten the nut to the prescribed torque using the
lock wrench and the torque wrench tools.
- Replace the plastic cover.
Specific tooling
020423Y driven pulley lock wrench
Locking torques (N*m)
Transmission cover screws
ley shaft nut
54 ÷ 60
End gear
ENG - 98
Driven pul-
11 ÷ 13
Beverly 125