Beverly 125
- Remove the shield back plate.
- Remove the front wheel housing.
- Remove the footrest.
N.B.
THIS OPERATION SHOULD PREFERABLY BE PER-
FORMED WITH THE TANK EMPTY.
- Separate the electrical connections of the fuel
gauge and disconnect the fuel supply line and tank
breather;
- Undo and remove the screw fixing the horn
shown in the upper figure after disconnecting the
electrical connection;
- Remove the toggle handles by loosening the 4
retaining screws;
- Remove the support bracket by loosening the 2
retaining screws of the bracket at the frame;
- Undo the two screws fixing the tank to the chas-
sis;
- Remove the tank by tilting it downwards and pull-
ing out from below.
See also
Footrest
Front wheel housing
Knee-guard
Front mudguard
- Remove the retaining screw of the cable lead
through support on the right-hand side of the mud-
guard. - Loosen the 3 fixing retaining screws indi-
cated in the figure and remove the mudguard.
Chassis
CHAS - 221