Function - Siemens 7XV5662-0AB01 Directions For Use Manual

Communication converter s0-bus with optical asynchronous input interface

Table of Contents

Available languages

English

Function

Figure 21 Hardware structure of the CC–S

The task of the Communication Converter S

, CC–S

, is to perform an adaptation of the

available fibre optic active interface in the protection device (DTE) to the physical specifica-

tion of the respective interface of the communication network (DCE, NTBA). The adaptation

occurs completely bit–transparent, i.e. direct forwarding of the information without adding or

filtering out information. Figure 21 shows the hardware structure.

The parameter assignment of the CC–S

is done via the PC–Interface (RS 232) and the

special configuration program, FOS0–Configurator, which can be downloaded from

http://

siemens.siprotec.de/download_neu/ind_acc_e.htm. Alternative a simple Terminal Program,

e.g. Hyper Terminal, can also be used.

The connection cable between the PC and CC–S

is the standard DIGSI

–communication

cable 7XV5100–4.

C53000-B1174-C166-1

Table of Contents

Table of Contents