Siemens 7XV5662-0AB01 Directions For Use Manual page 65

7XV5662-0AB01
Example 4:
Parameter assignment of the CC–S
connections via a terminal programmes. To start the assignment the CC–S
configuration mode. All parameters are listed in the next two tables 17 and 18.
Command
defa 1
aciomco 0
isdn 14
save
reset
Table 17: Leased line CC–S
Command
defa 1
aciomco 0
isdn 14
save
reset
Table 18: Leased line CC–S
Note: In opposite to a dialing line the parameter assignment of a leased line is easier. All
numbers are assigned by the communication switch so there is no need to assign any
number for the CC–S
necessary.
The communication link between the CC–S
communication switch. As far as the CC–S
transmission starts. In a leased line application any routing of the data is made by the
communication switch.
The routing from the D–channels to the fibre optic cables is also fixed. The B1–channel
is always routed to the FO1/LWL1 interface and the B2–channel is routed to FO2/
LWL2 interface.
C53000-B1174-C166-1
's in a two ended leased line application with two
0
Description
resets all parameter to the state of delivery
both B–Channel starts dialling after Reset/Power On or an
interruption of the communication
sets the ISDN–Protocol to leased line for both B–Channels
save the assigned parameters into a resident memory
restarts the CC–S
0
#1
0
Description
resets all parameter to the state of delivery
both B–Channel starts dialling after Reset/Power On or an
interruption of the communication
sets the ISDN–Protocol to leased line for both B–Channels
save the assigned parameters into a resident memory
restarts the CC–S
0
#2
0
's. Futhermore the choice of "DIAL" or "ACCEPT" is not
0
with the new assigned parameters
with the new assigned parameters
's and the S
0 0
's are connected to the S
0
must enter the
0
–Bus is established by the
–Bus the
0
English
65