Group 21
119. Install the speed governor.
IMPORTANT! The governor is uniquely prepared
for each engine. This means that the governor
can not be exchanged between different en-
gines.
An incorrect adjusted governor can result in that
the engine will not fulfill the regulations for emis-
sion and performance.
When ordering a governor as a spare part al-
ways state engine type's serial number, rated
speed (rpm), and x-measurement.
120. Tighten the torx screw in the sequence 1-2-3-4-5
using torx socket E 10. Tighten to .. 17 ±1.5 Nm
(12 ±1 lbf ft).
NOTE! For electronic governors the x-measurement is
entered as a value into the trigger unit. An electronic
governor is not unique with a calibrated x-
measurement.
121. For electronic governors, the following applies
for the 5 M8 screws:
1-2 = 70 mm
3-5 = 55 mm
Tighten the screws to ............................ 24 Nm
Starter motor
122. Fit the starter motor, if it has not been fitted
together with the transmission housing.
Tighten the screws to ............. 70 Nm (52 lbf ft).
123. Fit the cable and fixing clips.
Assembly, complete engine
77