Group 21
92. Tighten the screws to ............................... 21 Nm
(15 lbf ft).
NOTE! This does not apply to EDC 4 (electronic
governor).
Inlet pipes
93. Fit the inlet pipe with a new gasket.
Tighten the screws to .......................... 11 ±1 Nm
(8.1 ±0.7 lbf ft).
Fitting of injectors / delivery pipes
94. Using a little high temperature paste (1161035), fit
a new copper gasket (1) on the injector and fit the
injector.
NOTE! The connection for the fuel return line must be
towards the exhaust side.
95. Put the injector yokes (1) in place and tighten the
screws lightly.
Use Torx socket E10 (2).
Assembly, complete engine
71