Using Ssh To Access The Ctp Platform - Juniper CTP Series Hardware Manual

Circuit to packet platform

Hide thumbs Also See for CTP Series:

Table of Contents

Stop bits: 1

Flow control: Xon/Xoff

7. Click OK.

Using SSH to Access the CTP Platform

When you have configured an IP address for the CTP150 device, you can run SSH from a remote host to

access the device through its Ethernet port. To connect the Ethernet port to the network:

1. Connect an Ethernet RJ-45 cable to one of the two Ethernet ports on the front panel of the CTP150

chassis.

2. Connect the other end of the cable to the appropriate Ethernet network for an out-of-band connection.

CAUTION:

to communicate with the device. If you change the address, you will lose the SSH

session.

Table of Contents

Ctp150