Table of Contents
Advertisement
CHAPTER 19
Configuring Secure Web Access
Configuring the Basic Settings
Copyright © 2018, Juniper Networks, Inc.
Configuring the Basic Settings on page 117
Accessing the JSA Interface on page 120
NOTE:
When deploying a Juniper Secure Analytics (JSA) appliance with
image 2013.2.r3.607582, you must reimage the appliance to the common
image 2013.2.r3.615469 or above. For more information, see Installing JSA
Using a Bootable USB Flash-Drive Technical Note.
To configure the basic setting using the JSA interface:
NOTE:
When using a laptop to connect to the appliance, you must use a
terminal program, such as HyperTerminal, to connect to the appliance.
Power on the system.
1.
Select the appropriate COM port to use.
2.
Configure the following port settings:
3.
Bits per second =
9600
Stop bits =
1
Data bits =
8
Parity =
None
At the console prompt, log in as root (default username). No password is required
4.
when you log in for the first time.
Username:
root
117
Advertisement
Table of Contents
