Configuring The First Boot Script For The Ctp150 Device - Juniper CTP Series Hardware Manual

SEE ALSO
Before You Power On the CTP150 Device | 79
Powering Off the CTP Platform | 83

Configuring the First Boot Script for the CTP150 Device

For the first-time boot process, there is a series of login prompts that require the following settings:
1. Default username (ctp) and password (ctp). (We recommend that you change the root password after
entering the default.)
2. Supported protocol or protocols—(0) IPv4 only, (1) IPv6 only, or (2) IPv4 and IPv6. Enter the appropriate
number value.
3. Default interface—From the list of available devices, such as eth0 and eth1 (or more), enter the one to
be the default.
4. Hostname of the device.
5. IP address of the interface—Enter the IP address of the selected interface, or accept the loopback
address (127.0.0.1) by default.
6. Netmask of the IP address—Enter the netmask (such as 255.255.255.128), or accept 255.255.255.0
as the default.
7. Gateway IP address—Enter the IP address of the gateway, or accept the local address (127.0.0.1) as
the default
8. Maximum transmission unit (MTU)—Enter the MTU in bytes, or accept 1500 bytes as the default.
9. Static routes added to the default interface, if any.
10. Date and time GMT (more precisely, UTC)—Enter these separately in digits for the month, day, hour,
and minutes in Coordinated Universal Time (UTC), or accept the internal settings.
The device goes into startup mode.
81