Installing A Ctp Interface Module, Processor Module, Or Clock Module - Juniper CTP Series Hardware Manual

ESD wrist strap or other grounding device
RELATED DOCUMENTATION
Safety Guidelines and Warnings for Installing CTP Modules | 41

Installing a CTP Interface Module, Processor Module, or Clock Module | 65

Installing a CTP Interface Module, Processor Module, or Clock Module

To install a CTP module:
1. Ground yourself by using an antistatic wrist strap or other device, and connect it to one of the ESD
grounding jacks, if available, or another grounding device.
2. Choose the slot where you want to insert the module.
3. With a Phillips screwdriver, loosen the screws that secure the blank filler panel covering the empty
chassis slot, if present, and remove the filler panel.
4. Remove the module from its antistatic bag, being careful not to touch module components, pins, leads,
or solder connections.
5. Verify that the ejectors are in the open position (facing outward).
6. Guide the module into the chassis by placing it between the guides of the selected slot and pushing
the module until it stops.
The module stops sliding when the ejectors make contact with the chassis.
CAUTION:
using the ejectors, remove it from the chassis, and confirm that the slot is
designed to hold the component. Also, be sure that you have aligned the left
and right edges in the correct matching tracks.
7. Insert the module into the midplane by simultaneously pressing both ejectors inward and exerting
forward pressure on the module. The small red release buttons should click into place.
If you meet strong resistance when attempting to seat the module
65