Cabling A Ctp150 Interface Module; Ctp150 Fast Ethernet Cables - Juniper CTP Series Hardware Manual

Circuit to packet platform

Hide thumbs Also See for CTP Series:

Table of Contents

Cabling the CTP150 Platform Overview | 69

Cabling a CTP150 Interface Module | 71

Cabling a CTP150 Interface Module

To install a cable in an interface module:

1. Ground yourself by using an antistatic wrist strap or other device, and connect it to an ESD grounding

jack, if available, or another grounding device.

2. Slide the cable as far as you can into the module until it clicks into place.

3. Gently pull the cable to confirm that it is inserted correctly.

4. Go on to

"Before You Power On the CTP150 Device" on page

For more information about CTP150 Series cable and pinout specifications, refer Cable and Pinout

Specifications.

The Ethernet connection is a standard RJ-45 connector. Typically, a straight-through cable is used to

connect to a switch, and a crossover cable is used to connect to a router.

Table of Contents

Ctp150