Required Tools, Wires, And Cables For The Ctp150 Platform - Juniper CTP Series Hardware Manual

Circuit to packet platform

Hide thumbs Also See for CTP Series:

Table of Contents

Required Tools, Wires, and Cables for the CTP150 Platform | 70

Setting Up Management Access to the CTP150 Platform | 75

CTP150 Console Port Setup

Cabling a CTP150 Interface Module | 71

Required Tools, Wires, and Cables for the CTP150 Platform

Cabling your device takes only a few minutes. You need the following items and the cables listed in

Table 10 on page 70

for proper installation:

1/8-inch flathead screwdriver

3/8-inch wrench or 3/8-inch nut-driver

No. 2 Phillips screwdriver

Ground wires—We recommend a minimum of 18-AWG ground wire for AC and DC-powered versions,

if applicable.

Two #10 kep nuts (supplied) to connect the ground (earth) wire to the ground terminal.

Power module wiring—We recommend a minimum of 18-AWG wire for the device with a dual stud

terminal lug with 5/8-inch spacing.

Consider the distance from the connection point and the configuration of the device when determining

the size of wire used.

Table 10: Required Cables

Connection

Management connection between the processor module

and the LAN

Management connection between the processor module

and a management console

Direct connections to interface modules

For more information about CTP150 Series cable and pinout specifications, refer Cable and Pinout

Specifications.

Table of Contents

Ctp150