Planning And Preparing The Site; Before You Install A Ctp Platform; Ctp150 Environmental Requirements - Juniper CTP Series Hardware Manual

Circuit to packet platform

Hide thumbs Also See for CTP Series:

Table of Contents

CHAPTER 4

Planning and Preparing the Site

IN THIS CHAPTER

Before You Install a CTP Platform

Before you install a Juniper Networks CTP Circuit to Packet platform:

Verify that the electrical supply meets all power requirements. See the system specifications for the

applicable CTP model.

Verify that the site meets all environment specifications. Refer to the environmental requirements and

the system specifications for the applicable CTP model.

Verify that the cables you plan to use meet the specifications, and review the cabling recommendations.

Verify the operation of all telephone circuits, digital services, and T1 facilities required for installation.

Ensure that all IP requirements are met, such as IP addresses, subnet masks, and any specific routing

protocol information.

CTP150 Environmental Requirements

See the

"CTP150 Platform Specifications" on page 15

Choose a location for the device that is dry, relatively dust free, well ventilated, and air conditioned. If you

install equipment in a rack, be sure that the floor is capable of supporting the combined weight of the rack

and the installed equipment. Place the device in a location with sufficient access to power and network

cables.

Like other network devices, the device generates a significant amount of heat. You must provide a balanced

environment so that the device performs properly and safely. See the individual system specifications for

acceptable ranges of temperature and humidity.

for complete environmental specifications.

Table of Contents

Show Quick Links

Table of Contents

Ctp150