Installing The Cna Module On The Jsa1500 Appliance; Figure 27: Mid-Mount In Two-Post Equipment Rack - Juniper JSA1500 Hardware Manual

Juniper Secure Analytics Hardware Guide
Related
Documentation

Installing the CNA Module on the JSA1500 Appliance

110

Figure 27: Mid-Mount in Two-Post Equipment Rack

Attach the front bracket to the chassis, and secure
the chassis to the post. Attach the rear bracket to the
other side of the post, and secure the chassis to
the rear bracket, adjusting the bracket width as needed.
Verify that the mounting screws on one side of the rack are aligned with the mounting
4.
screws on the opposite side and that the appliance is level.
Rack-Mount Installation Overview on page 89
Front-and-Rear-Mounting the JSA Appliance Flush to a Rack on page 104
Front-and-Rear-Mounting the JSA Appliance Recessed in a Rack on page 105
To install the Converged Network Adapter (CNA) module on a JSA1500:
Power down the JSA1500 unit.
1.
Unscrew the two thumbscrews on the right-most blank IOC modules and remove the
2.
dummy tray.
NOTE:
The IOC module supports 10G connectivity with SFP+ transceivers. It
supports only 1G connectivity using dual-rate optics:
UNIV-SFPP-DUAL-SR and UNIV-SFPP-DUAL-LR.
The JSA1500, JSA3500, and JSA5500 support both 4-port 1G IOC or
2-port 10G IOC modules. The JSA7500 supports only the 2-port 10G IOC
module in a one-half height tray.
Insert the 2-port 10G CNA module firmly and screw in the two thumbscrews. See
3.
Figure 28 on page 111.
Copyright © 2018, Juniper Networks, Inc.