Step 1: Prepare The Site For Srx5600 Firewall Installation; Rack-Mounting Requirements - Juniper SRX5600 Manual

Table 1: Minimum System Configuraton
Component
SCB
Routing Engine
For detailed information about the cards supported by the firewall, see the
SRX5800 Firewall Card Reference
The firewall is shipped in a cardboard box strapped securely to a wooden pallet. Plastic straps secure the
top and bottom in place. The firewall chassis is bolted to this pallet. A printed copy of this document and
a cardboard accessory box are also included in the shipping container.
Step 1: Prepare the Site for SRX5600 Firewall
Installation
IN THIS SECTION

Rack-Mounting Requirements | 2

Tools Required to Unpack and Prepare the SRX5600 Firewall for Installation | 4
Rack-Mounting Requirements
• You can install the firewall in a four-post rack or cabinet or an open-frame rack.
• The rack rails must be spaced widely enough to accommodate the firewall chassis's external
dimensions: 14.0 in. (35.6 cm) high, 24.5 in. (62.2 cm) deep, and 17.45 in. (44.3 cm) wide. The outer
edges of the mounting brackets extend the width to 19 in. (48.3 cm). See
(Continued)
at www.juniper.net/documentation/.
Minimum
1
1
SRX5400, SRX5600, and
Figure 1 on page 3.
2