Symmetricom ATS-6501 Tflex User Manual page 99

[tsc4373]
[ports]
[1]
[pps_period] 1
[pps_width] 1.000000000000000e-04
[type] pps
[2]
[pps_period] 1.000000000000000e-06
[pps_width] 5.000000000000000e-07
[type] pps
[3]
[format] B
[signal_word] 0
[type] irig
[4]
[format] B
[signal_word] 0
[type] irig
Prompt:
Description: Allows the user to change the command prompt text, turn the prompt on (1)
or off (0) and can make that change for the current session or the system default.
Syntax: prompt –text(text) –enable(0/1) --default
Command Example:
This command changes it for the current session.
ATS-6501>prompt –text Test
Test>
ATS-6501>prompt –enable 0
Prompt is no longer visible. This change is only in effect for the current telnet session.
Command Example:
This command makes it the system default.
ATS-6501>prompt –text Test --default
ATS-6501>
ATS-6501>prompt –enable 0 --default
ATS-6501>
Query:
ATS-6501>settings command_port
[prompt]
[enable] true
[text] Test>
Note: Making any changes without the –default option will impact the current session and
will not impact the system settings. Using the –default option will change the system
settings (settings command_port) values and will be used the next time the user makes a
command port connection. These settings must also be saved.
Changes the prompt immediately, only in effect for the current telnet session.
Note: Prompt does not change until the next command port connection is made.
Prompt is still visible, Prompt does not disappear until the next
command port connection is made.
93
DOC06501_Revision F
ATS-6501 Users Guide