Symmetricom ATS-6501 Tflex User Manual page 46

To set up the real time data logging users will need to follow the steps outlined below to set
up the type of data to be logged and then turn the logging on. Users can also verify the data
logging configuration settings.
A. Telnet into the command port (1700).
B. Use the log rt <novalog> command to set up they data type to be sent over the data port.
The novalog text on the command line specifies which data type to forward over this
port. Some examples are provided below.
ATS-6501>log rt timea ontime 1
ionutca onchanged
rawalma onchanged
rangea ontime 60
ionutca ontime 7200
rawephema onchanged
waas9a onchanged
C. If needed, turn the real time logging on using the log_enable rt command.
ATS-6501>log_enable rt 1
D. You can verify the real time log settings using the settings gps_logging:rt command.
ATS 6501>>settings gps_logging:rt
[enable] true
[log_selection]
[timea] ontime 1
[waas9a] onchanged
E. The data requested will now be available on port 1135.
Users can make changes to the desired information that is being logged by using the log
command to add logs as described above or delete a desired log using the unlog command. To
delete the desired data type use the unlog rt [datatype] command to remove the desired data from
the list. Users can remove all of the log files simply using the unlog rt all command.
ATS-6501>unlog rt waas9a
OK
ATS 6501>settings gps_logging:rt
[enable] true
[log_selection]
[timea] ontime 1
Once the desired changes are made save the set up using the save_logs rt command.
ATS 6501>save_logs rt
OK
// log IONO & UTC data
// log almanac on startup
// L1/L2 observations @ 60 seconds
// log IONO & UTC data every 2 hours
// log broadcast ephemerides
// log WAAS data
40
DOC06501_Revision F
ATS-6501 Users Guide