Symmetricom ATS-6501 Tflex User Manual page 97

Network
Description: Displays the current system network settings as set by the user. Short-cut for
show network.
Syntax: network
Note: These settings are not necessarily what the system is currently using unless the
system has static IP Address assigned. If the system is using DHCP the current IP settings
being used by the system will be displayed using the status tflex:network command.
Command Example:
ATS-6501> network
Query:
ATS-6501>network
[broadcast] 192.168.1.255
[default_gateway] 192.168.1.1
[ip] 192.168.1.50
[mode] static
[netmask] 255.255.255.0
Network Configuration
Description: Allows the user to change the mode for setting the IP Address (DHCP /
static) and assigning the network settings when using a static IP Address.
Syntax: network_config --mode (DHCP/static) --ip <IP Address> -- mask <netmask>
-- broadcast <Broadcast IP> --gateway <Gateway IP>
Command Example:
ATS-6501> network_config --mode static --ip 192.168.1.50 --mask 255.255.255.0 --broadcast
192.168.1.255 --gateway 192.168.1.1
Note: These network settings will take effect immediately. Users should see "<working>"
with a series of periods on the screen. Once the new settings take effect the connection will
time out and drop. Users will need to reconnect to the system using the newly assigned
static IP Address. These settings are also stored on the system automatically and the
system will start up with these settings each time it is rebooted or power cycled.
Query:
ATS-6501>network
[broadcast] 192.168.1.255
[default_gateway] 192.168.1.1
[ip] 192.168.1.50
[mode] static
[netmask] 255.255.255.0
If = DHCP – check status tflex:network for current settings
91
DOC06501_Revision F
ATS-6501 Users Guide