Symmetricom ATS-6501 Tflex User Manual page 21

[pps_period] 1.000000000000000e-06
[pps_width] 5.000000000000000e-07
[type] pps
[3]
[format] B
[signal_word] 0
[type] irig
[4]
[format] B
[signal_word] 0
[type] irig

IRIG: Valid DC IRIG Codes are A(000,003,007), B(000,003,007), D002, E002,
G002, and H002. Default is B000. To set the IRIG Code for the individual ports use the
irig command:
ATS-6501> irig [slot#] [port#] [Code A-H] [Code Format <NNN>]
The following example sets the IRIG for Slot 1, Port 3 to A 003.
ATS-6501>irig 1 3 A 003
The system will generate an error message if the operator attempts to enter an
unsupported or invalid code.
To verify the settings use the settings hardware:outputs:slots:N command (where N=Slot
#) to obtain the current settings for a particular card.
ATS-6501> settings hardware:outputs:slots:1
[tsc4373]
[ports]
[1]
[pps_period] 1
[pps_width] 1.000000000000000e-04
[type] pps
[2]
[pps_period] 1.000000000000000e-06
[pps_width] 5.000000000000000e-07
[type] pps
[3]
[format] A
[signal_word] 3
[type] irig
[4]
[format] B
[signal_word] 0
[type] irig
Note: The system will drop the leading Zeros in the signal_word.
To verify the card is working properly use the status hardware:outputs:slots:N command
(where N=Slot #) to obtain the current settings for a particular card.
ATS-6501>status hardware:outputs:slots:1
[ports]
15
DOC06501_Revision F
ATS-6501 Users Guide