11Steering A Route With The Navpilot - Furuno NavNet TZtouch3 Series Operator's Manual

5. ROUTES
tion section 5.11.3. If an autopilot is connected, the ship turns after passing the
final destination and continues to sail around the final destination.
Note: The rudder may be suddenly turned depending on the make of autopilot
and vessel speed.
To cancel route navigation after reaching the final destination, select [Stop Navi-
gation].
3. Tap the close button on the title bar to finish.
5.11.11 Steering a route with the NAVpilot
When you select a point to follow and the NAVpilot-700 series is engaged and activat-
ed (see subsection 2.13.1) in the system, the message "DO YOU WANT TO NAVI-
GATE USING THE NAVPILOT?" appears. Tap [Yes] to have the NAVpilot steer the
vessel, then the NAVpilot automatically goes into the NAV mode. For the NAVpilot-
300, you are asked to select a navigation mode. Select [Precision] or [Economy].
([Cancel] stops the NAV mode.) After selecting a mode, the NAVpilot-300 automati-
cally goes into the NAV mode.
Precision mode: Keeps XTE within 0.01 NM
Economy mode: Keeps XTE within 0.03 NM
Note: The example figure below shows the NAVpilot's display in the NAV mode. See
section 2.13.3 for details.
5-18
Tap this area to switch to
manual (standby) mode.
Turn/Menu button.
Appears in all modes for
NAVpilot-300 series only.