Furuno NavNet TZtouch3 Series Operator's Manual page 31

Based on the menu settings shown on the previous page, the installed configura-
tion should look similar to the following image.
MCU1
FLYBRIDGE
(A) and (B) can STBY STBY HOME
• •
AUTO AUTO BRILL
FUNC
CURS
• CENTER
be controlled SCRL
from MCU1.
CANCEL
MOB
MCU2
FLYBRIDGE
(C) and (D) can
STBY STBY HOME
• •
AUTO AUTO BRILL
FUNC
be controlled
CURS
• CENTER
SCRL
from MCU2.
CANCEL
MOB
3. Select the displays to cycle.
4. Set the order. To skip a display, select it to [Off].
5. Tap "<" on the title bar to return to the [REMOTE CONTROLLER CONFIGURA-
TION] menu.
6. Tap the [Confirm] button on the title bar to save settings and close the menu.
A TZT12F_FB_LEFT
C TZT19F_MB_LEFT
1. SYSTEM INTRODUCTION
B TZT12F_FB_RIGHT
D TZT19F_MB_RIGHT
HUB
1-11