Furuno NavNet TZtouch3 Series Operator's Manual page 375

Text
DSC Distress Call
DSC Position Report Re-
ceived
Radar Connection Lost
Radar Trigger Alarm
Radar Video Alarm
Radar Azimuth Alarm
Radar Headline Alarm
TARGET ALARM
Antenna FAN RPM is Low
Bird Mode Activated
Bird Mode Deactivated
Target Analyzer Requires
24NM Range or Less
Cannot intercept target at
current speed
Fish Finder Connection
Lost
Fish detected - Bottom
Multibeam Sonar Discon-
nection Alarm
Multibeam Sonar B Voltage
Abnormal
Multibeam SONAR Fish
Detected
Sirius Disconnection Alarm Connection with the Siri-
Weather Update in Prog-
ress
Meaning
A distress warning is re-
ceived.
A non-distress DSC mes-
sage is received.
Connection with the select-
ed radar sensor is lost.
Trigger signal error.
Video signal error.
Bearing pulse signal error.
Heading pulse signal error. Check the reed switch and magnetron of
A target has entered the
guard zone.
Problem with the fan of the
radar sensor.
The bird mode is turned on.
The bird mode is turned off.
The radar sensor is
DRS6A-NXT and the target
analyzer is set to 24 NM.
The target cannot be inter-
cepted at the current ship
speed.
Connection with the select-
ed fish finder is lost.
A fish school is detected
within the range set for the
bottom lock fish alarm.
Connection with the multi-
beam sonar is lost.
The B voltage of the multi-
beam sonar is outside the
specified value (32.4 to
39.6 V).
A school of fish is detected
within the range set for the
fish alarm of the multibeam
sonar.
usXM receiver is lost.
The latest weather data is
being downloaded from the
internet.
APPENDIX 3 ALERT MESSAGES
Remedy
You cannot delete this message manu-
ally because this is an emergency warn-
ing.
This message is erased when a
non-distress DSC message is lost.
Reconnect the radar sensor.
Check the radar antenna. Check the
connection with the radar antenna.
Check the radar antenna. Check the
connection with the radar antenna.
Check the radar antenna. Check the
connection with the radar antenna.
the radar antenna. Check the connec-
tion with the radar antenna.
Take evasive action immediately. Tap
the guard zone to cancel the alarm.
Check the fan of the radar sensor.
–
–
Set the target analyzer within the config-
urable range (within 16 NM).
Raise the ship speed.
–
–
Check the connection with the multi-
beam sonar.
Have a qualified technician check the
connection between the PWRTRX
board and the DIGI board of the multi-
beam sonar. If there is no problem with
the connection and no echo is produced,
the PWRTRX board is faulty. Contact
your dealer for advice.
–
Check the connection with the SiriusXM
receiver.
This message disappears after the
weather data is obtained.
AP-19