How To Show The Detailed Information About A Route - Furuno NavNet TZtouch3 Series Operator's Manual

5. ROUTES
• A solid purple line with arrows connects between current position and the points on
the route. This line indicates the set course. A solid yellow line runs between runs
between current position and the destination. This line shows the shortest distance
to the destination.
• The arrival area marker appears if activated on the menu (see subsection 5.11.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines and set their width with [Display XTE Lines] and [XTE Value] re-
spectively in [Routes] menu.
Note 1: If you want to be notified when you reach a Goto point, turn on [Waypoint
Crossing Notification] in the [Routes] menu (see subsection 5.11.8). Then the mes-
sage "Waypoint Crossing" appears when you reach a Goto point. For the arrival tim-
ing, see subsection 5.11.5.
Note 2: You can also start navigating a route from any location on a route leg. Tap
anywhere on a route leg to show the pop-up menu, then tap [Start from Here] to have
that location become the destination.
5.10.4

How to show the detailed information about a route

1. Tap a route leg of the route to show the pop-up menu.
2. Tap [Detail] to show the [Route Detail] window.
3. Tap the close button on the title bar to finish.
About the Route Detail window
The colored bars at the left edge of the window denote the status of each route point.
Gray: A route point already transited.
Yellow: The route point your vessel is currently heading toward.
Purple: Route points other than the current destination.
[ID]: [Start], or route point number
[BTW]: Bearing To Waypoint
[SPEED]: Speed used to calculate route details
[DISTANCE]: Distance to waypoints
[TOTAL]: Total distance of route
[TTG]: Time to Go between each route point*
[TOTAL]: Total time to go from start*
* Calculation based on [SPEED] value.
5-14