Wireless Lan Settings; How To Connect The Existing Lan - Furuno NavNet TZtouch3 Series Operator's Manual

1.19

Wireless LAN Settings

You can connect to the internet with the wireless LAN signal to download weather in-
formation (see chapter 13). Also, using wireless LAN, you can connect an iOS or An-
™
droid device to monitor the NavNet TZtouch3 from the connected device.
The wireless LAN can be used two ways:
• Use existing LAN: Connect to an existing LAN access point (in a harbor, etc.) to
download weather information.
• Create local network: Create an access point from which the NavNet TZtouch3 can
be monitored, controlled from a smartphone or tablet.
About the wireless LAN
• The wireless LAN function is available only in the countries which have acquired ra-
dio wave certification. Turn this function off in countries which do not have radio
wave certification. Ocean-going vessels that have radio wave certification can use
the wireless LAN function in any country that has acquired radio wave certification.
Vessels with radio wave certification that enter a country that does not have radio
wave certification may use the wireless LAN function only onboard the vessel.
Available countries (as of 04/2018): USA, Canada, New Zealand, Australia, Japan,
and all countries of the EU.
• The communication rate and effective range for the wireless LAN can be affected
by electromagnetic waves, interfering objects, or access point location.
• We strongly recommend using the wireless LAN with encrypted connection. Other-
wise unauthorized access by a third party can occur, which can cause loss of data
or system crash.
• We recommend changing the initial password before using a local wireless network.
1.19.1

How to connect the existing LAN

1. Go to the Home screen, then tap [Settings]→[General]→[Connect to the Internet].
2. Tap [When Necessary]. Tap "<" to go back one layer.
3. Tap [Wireless LAN Settings]→[Wireless Mode].
4. Tap [Connect to existing LAN]. Tap "<" to go back one layer.
1. SYSTEM INTRODUCTION
1-39