How To Export User Objects; How To Import User Objects - Furuno NavNet TZtouch3 Series Operator's Manual

9. FILE OPERATIONS
[TZD]: For NavNet TZtouch2
[CSV]
[GPX]
*1
* : The CSV format has the following export restrictions:
• Points: Max. 2,000
• Routes: Max. 200 (100 points/route)
• Track: Max. 10,000
*2
: When exporting data in GPX format, it is recommended to make a note of the
data contained in the file. GPX files names do not indicate their contents.
4. Tap the close button on the title bar to finish.
9.2

How to Export User Objects

This unit holds a maximum of 30,000 points, 200 routes, 100 polygon areas, (bound-
aries), 100 circles (boundaries), 1,000 screenshots, and 1,000 catches. When the ca-
pacity for routes/points is full, new data cannot be stored. If you need to save the
above-mentioned items permanently, save them to a media, following the procedure
below.
1. Put the appropriate formatted media in the USB port.
2. Open the Home screen, then tap [Settings]→[Files]→[Export User Objects].
3. A confirmation message asks you if you are sure to proceed.
4. Tap [OK]. The message "EXPORT SUCCEEDED" appears if the exporting was
successful.
5. Tap [OK] to erase the message.
6. Tap the close button on the title bar to finish.
9.3

How to Import User Objects

You can import points, routes and boundary lines to the internal memory of this unit,
using a SD card, microSD card or USB flash memory.
1. Put the appropriate formatted media in the USB port.
2. Open the Home screen, then tap →[Files]→[Import User Objects]. A list of files
stored on the inserted media appears.
3. Tap the file(s) to import. You are asked if you are sure to import selected items.
9-2
*1
: For NavNet3D
*2
: For use with PC plotter
USB 1
XXXX. XXX.tzx
XXXX. XXX.tzx
XXXX. XXX.tzx
XXXX. XXX.tzx