Table of Contents
Advertisement
11 - OPERATION (continued)
11.2 Operation Warnings
1. Turn electrical and air supply off and disconnect before servicing taping heads or performing any
adjustments or maintenance on the machine. Turn electrical and air supplies off when machine is not
in use.
2. Do not leave machine running unattended.
3. Before turning drive belts on, be sure no tools or other objects are on the machine bed.
4. Keep hands and loose clothing away from moving belts and fl ap kicker.
5. Keep away from fl ap kicker. Flap kicker is controlled by air and can be activated (if air supply is "On")
by depressing fl ap kicker cam. Be sure fl ap kicker is in the down position before servicing.
6. Never attempt to remove jammed boxes from the machine while machine is running.
7. Machine access door must be closed when drive belts are running. Do not attempt to override door
interlock switch.
8. Keep hands and clothing away from taping heads when machine is running. A box traveling through
the machine causes taping head rollers to retract when box enters and extend as box leaves taping
head.
9. Both the upper and lower taping heads utilize extremely sharp tape cut-off knives. The knife is located
under the orange knife guard which has the "WARNING – SHARP KNIFE" label. Before loading tape,
refer to Manual 2 to identify the knife location. Keep hands out of these areas except as necessary to
service the taping heads.
10. Failure to comply with these warnings could result in severe personal injury and/or equipment
damage.
800af-I-NA
WARNINGS
29
2010 December
Advertisement
Table of Contents
