Table of Contents
Advertisement
13 - ADJUSTMENTS (continued)
•
To reduce the risk associated with pinches and entanglement hazards:
−
Do not leave the machine running while unattended.
−
Turn the machine off when not in use.
−
Never attempt to work on any part of the machine, load tape, or remove jammed boxes from the
machine while the machine is running.
13.4 Upper Taping Head Leveling
If the upper taping head is not horizontal, it can be leveled by adjusting the self-locking nut.
1. Loosen the fi ve (5) bolts on each side of crossbar shown in Figure 13-2A.
2. Remove access cover as shown in Figure 13-2B and (using M13 hex key wrench) tighten or loosen M8
self-locking nut until upper head is level.
3. Take measurement from exit end of upper head assembly and front of fl ap folding ski to machine bed, as
shown in Figure 13-2. Upper assembly must be level ±1.5mm [±1/16 inch].
4. Retighten fi ve (5) bolts on each side of crossbar to secure adjustment.
A
B
Figure 13-2 – Upper Taping Head Leveling
800af-I-NA
WARNING
41
Take
Measurement
Here
2010 December
Advertisement
Table of Contents
