3M -Matic AccuGlide 2+ 800af Instructions And Parts List page 43

11 - OPERATION (continued)
Figure 11-11
Run several test boxes through the machine, and
observe the fl ap kicking action. Adjust the kicker
cam so the kicker "kicks" earlier or later as required
(refer to fi gure 11-11). In general, it is better to set
the kicker to "kick" early because it contacts the fl ap
higher above the score-line which results in more
reliable fl ap folding.
WARNING
•
To reduce the risk associated with
impact hazards:
− Always use appropriate supporting
means when working under the upper
drive assembly
Figure 11-12
The upper side fl ap folding guides can be adjusted
in or out to accommodate the width of the box. For
optimum performance, the side fl ap folding guides
should be adjusted to the narrowest position which
allows them to catch any side fl aps that may be bent
outward past vertical.
Note – Box fl aps should not be bent outward
past vertical more than 15° when
entering case sealer.
800af-I-NA
Figure 11-11 – Box Size Set-Up
Top View
(Infeed End)
Figure 11-12 – Box Size Set-Up
33
Flap
Folding
Guides
2010 December