Table of Contents
Advertisement
11 - OPERATION (continued)
Figure 11-7
Place a product fi lled box 55 to 65mm [2-1/4 to
2-1/2 inches] into the exit end of the machine with
the top fl aps folded as shown.
Crank the upper head down until it just contacts the
top of the box.
Crank the side drive belts in until the belts fi rmly grip
the box.
Figure 11-8
Set Kicker cam relative to length of box being
sealed. Measure the distance "X" as shown and set
the cam to the same dimension measured on the
box (this dimension provides a good starting point
for setting the kicker cam).
Note: 5mm hex key wrench is supplied with
machine and should be kept in wrench
holder on side of upper frame.
800af-I-NA
55 to 65mm
[2 1/4 to 2 1/2 in]
Figure 11-7 – Box Size Set-Up
Infeed
End
Figure 11-8 – Box Size Set-Up
31
"X"
5mm Hex Key
2010 December
Advertisement
Table of Contents
