Gb/S Optical Output Checks (If Fitted); Oc-192/Stm-64 Power Level And Eye Mask Tests - Agilent Technologies J2126A Installation And Verification Manual

Transmission test sets
Hide thumbs Also See for J2126A:
Table of Contents

Advertisement

10 Gb/s Optical Output Checks (if fitted)

Installation and Verification Manual

OC-192/STM-64 Power Level and Eye Mask Tests

1 Press <Menu>, choose Tx/Rx > Stored Settings then press
<Select>. Select Default then Recall.
2 Press <Menu>, choose System > Preferences then press
<Select>. Set Network Standard to SONET.
Set the transmit Signal Rate to OC192. Ensure the Laser is
set to OFF.
3 Connect the 10 Gb/s Optical Out Port to the Oscilloscope
using an Optical Patch cord. Also connect the connect the TX
Eye Clock (10 Gb/s) to the scope Trigger input as shown.
Performance Tests
95
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

J2127a

Table of Contents