2
Installation (Getting Started)
CAU TI O N
36
appropriate power cord is not included with the instrument
notify the nearest Agilent office and a replacement will be
provided.
Power cable configurations and part numbers
Removing the Instrument Covers
The instrument covers are a press-fit. To remove them, gently
lever them off.
When transporting the instrument, always replace both covers
to protect the instrument connectors and display.
Connecting the Mouse Cable
To ensure complete compliance with the EMC regulations specified for
the instrument, you must attach a ferrite bead to the connector end of
the mouse cable.
Your mouse cable may not look identical to the one illustrated,
but the instructions are the same. Snap open the ferrite bead
(supplied with the instrument) and attach it as close to the
cable plug as possible, wind the cable twice through the
28A2025-0A0 bead, then snap it shut. To stop the bead sliding
along the cable attach the tie wrap (also supplied with the
instrument) round the cable just after the bead.
Installation and Verification Manual