Description Of Each Part Of Probes; 5� Description Of Each Part Of Probes - Konica Minolta CA-410 Instruction Manual

5� Description of Each Part of Probes
(5)
(2)
(3)
zProbe other than mini z
Note: CA-P427, P427H, P410, and P410H have another tripod mount screw
on the front side of the ISO screw. For details, refer to the dimensions.
(1) Receptor
Make this part face perpendicular to a display to perform measurement.
(2) USB connector
For USB connection with a data processor or a PC, connect the USB cable IF-A28 supplied as a standard accessory.
(3) RS-232C connector
For RS-232C connection to a data processor, connect the mini DIN cable IF-A30/31/32 for the data processor to the
RS-232C connector.
For RS-232C connection with a PLC or PC, connect an optional conversion cable IF-A29.
Use a conversion cable IF-A29 or a BNC conversion cable IF-A35 to input the display's vertical synchronization signals, which
are used for measurement in "EXT" measurement synchronization mode.
(4) Screw holes
There are two types of screws for securing a probe:
Tripod mount screw: Used for mounting the probe on a tripod. The depth is 6 mm.
ISO screw: Used for securing the probe to jigs. Use an ISO 5 mm screw and the depth is 6 mm.
• The distance from each screw to the end of the optical column is the same as that for a CA-310 series probe. (Excluding
mini probes, the CA-VP402, the CA-VP404, and the CA-VP410T.)
• The position of the optical axis (in the height direction) is the same as that for a CA-310 series probe.
(5) Status indicator
Located on the rear of all probes to indicate the status of the probe.
No power supply: Off
During measurement or zero calibration: Off
Memory error: Blinking (On for 0.2 sec, then Off for 0.2 sec)
Zero calibration not performed: Blinking (On for 1 sec, then Off for 0.2 sec)
Measurement possible: On (even when measurement is not possible due to the setting of an invalid synchronization
frequency or integration time in INT, EXT, or MANUAL sync mode, without displaying that state)
(4) (4)
ISO screw Tripod mount screw
(1)
zMini probe z
Note: Mini probes have screws for jigs and
cable clamps. For details, refer to the
dimensions.
15
(4) (4)
ISO screw Tripod mount screw
(2)
(3)