Names And Functions Of Parts - Konica Minolta CA-410 Instruction Manual

Names and Functions of Parts

<Front>
(1) [BACKLIGHT] key ���������������� Switches the backlight of the LCD display ON/OFF.
(2) [DATA] key �������������������������� On the measurement screen, press this key to switch to the data screen for checking or
(3) [ESC] key ���������������������������� On the menu, setting, or setting check screen, press this key to return to the measurement
(4) [MODE] key ������������������������ On the measurement screen, press this key to switch color modes.
(5) [CAL CH] key ���������������������� On the measurement screen, press this key to display the screen for selecting a calibration
(6) [MENU] key ������������������������ Toggles the screen between the measurement and setting screens.
(7) [UP/DOWN] keys ��������������� Moves to the upper/lower items or increases/decreases the setting value.
(8) [LEFT/RIGHT] keys ������������� Switches to the left/right tab or moves to the left/right item.
(9) [ENTER] key ����������������������� Pressing this key when a menu item is selected displays the screen for setting the item.
(10) [0-Cal] key ������������������������ Performs zero calibration.
(11) [HOLD] key ����������������������� Switches between hold and measurement modes every time the key is pressed. (Refer to
(12) Display screen ������������������ Displays information such as measurement results and settings.
(12)
deleting measurement results and logs. (Refer to page 90 "4. Checking and Deleting
Measurement Data" in the Measurement section.)
screen. Pressing this key while configuring the settings returns the display to the previous
screen. Pressing this key while entering a value cancels the current entry.
Press and hold for 2 seconds or more to lock the keys. Press and hold again to release the key
lock. All key operations other than the [ESC] key, [0-Cal] key, [BACKLIGHT] key, and power
switch are disabled while the keys are locked.
(Refer to page 37 "4. Changing Color Modes" in "Operations on Each Screen".)
(Lv,x,y -> Lv,u',v' -> Lv,Tcp,duv -> X,Y,Z -> Lv,λd,Pe -> FMA -> JEITA -> Lv,x,y)
channel. (Refer to page 87 "1. Performing Measurement" in the Measurement section.)
Pressing this key during value input or setting confirms the current entry.
page 88 "2. Holding the Measured Values" in the Measurement section.)
(10)
(4)
(5)
(6)
(8)
(9)
(11)
28
(1)
(2)
(3)
(7)