Ethernet Connection; Connection To A Pc Via Ethernet - Konica Minolta CA-410 Instruction Manual

Ethernet Connection

1� Connection to a PC via Ethernet
An Ethernet cable can be connected/disconnected even if the power to the instrument is ON. In the following procedure,
however, the power is turned OFF before a cable is connected.
Use an Ethernet cable to connect the instrument to a PC.
Notes
• Connect the connector plug firmly in the correct direction.
• When connecting/disconnecting the cable, be sure to hold the connector plug. Do not hold the cable and pull or bend it
with unreasonable force. Doing so may break the cable.
• Make sure that the cable has sufficient length. Putting tension on the cable may cause connection failure or wire
breakage.
• Pay attention to the shape of the port (connecting terminal) for the cable connector, and push the connector completely
into the port.
Operating Procedure
1
Set the POWER switch to OFF ()�
2
Connect an Ethernet cable to the
Ethernet connector of the instrument�
3
Check that the plugs are inserted all the
way and connected firmly�
4
Turn the instrument power ON�
• As an Ethernet cable, use a 100Base-TX or a 10Base-T cable.
• If the PC has several Ethernet ports, any port can be used. Note, however, that the instrument may not operate properly
when it is used simultaneously with another device.
Ethernet connector
111
Ethernet cable