Ricoh A318 Service Manual page 70

REPLACEMENT AND ADJUSTMENT
12.1.8 Friction Belt Replacement
1. Turn off the main switch.
2. Remove the seal cover [A] on top of the DF cover.
3. Remove the friction belt assembly [B] (1 screw).
4. Remove the friction belt [C] (2 springs, 1 pin).
NOTE: a) When installing the friction belt assembly, make sure the
friction roller [D] is set in the correct position (see illustration).
b) If the seal cover becomes dirty or deformed, replace it with a
new one.
[D]
44
[A]
[C]
1 May 1993
[B]