Ricoh A318 Service Manual page 33

INSTALLATION PROCEDURE (for Machine Code: A110/A111)
[C]
25. Adjust the height of the magnet catches in the following order:
1) Remove the grip cover [A] (3 screws)
2) Loosen the screws of the magnet catches [B] (2 screws each)
3) Close the document feeder and tighten the screws of the magnet
catches when the rubber stopper [C] contacts the exposure glass.
26. Reinstall the grip cover (3 screws).
NOTE: Open and close the document feeder confirming that the magnet
catches are making good contact.
27. Plug in the copier and turn on the main switch.
28. Confirm the original registration. (See page 33.)
29. Reassemble the copier. (The DF harness fits in the cut-out on the rear
cover as shown.)
30. Check the operation of the DF.
31. Position the original select switch to thin paper mode (normal position)
and explain the function of this switch to the customer.
[A]
[B]
32
1 May 1993