Ricoh A318 Service Manual page 65

1 May 1993
12.1.4 Feed-in Clutch Lubrication
1. Turn off the main switch.
2. Remove the original set sensor assembly. (See Pick-up Roller
Replacement.)
3. Remove the feed-in solenoid lever spring [A].
4. Remove the pick-up roller assembly [B] (2 E-rings, 2 bushings).
5. Disassemble and lubricate the feed clutch [C] (1 E-ring) with Mobil Temp.
78.
NOTE: a) Be careful not to loose the pin [D].
b) When installing the feed clutch, make sure the positioning pin is
correctly inserted in the cut-out of the clutch.
REPLACEMENT AND ADJUSTMENT
[B]
[A]
39
[D]
[C]