Ricoh A318 Service Manual page 67

1 May 1993
5. Turn off DPS101-1 and 2, then turn on DPS101-3 and 4 [B].
6. Loosen the screw fixing the pick-up solenoid [C].
7. Place the 0.15 mm thickness gauge [D] between the plunger and the
solenoid.
8 While holding the solenoid, press SW101 [E] on the DF main PCB to
engage all DF solenoids.
9. Holding the solenoid securely, move it slowly towards the left, until the
plunger is attracted to the solenoid. Just at this point, tighten the screw.
NOTE: Make sure the pick-up lever is touching the pick-up roller during
this adjustment.
10. Press SW 102 [F] to turn off the solenoids.
11. Turn off DPS101-3 and 4, then turn on DPS101-1 and 2.
12. Turn off the main switch and reassemble the DF.
13. Check the original feed-in operation.
REPLACEMENT AND ADJUSTMENT
41