Ricoh A318 Service Manual page 58

INSTALLATION PROCEDURE (for Machine Code: A072)
[A]
[C]
18. Adjust the height of the magnet catches in the following order:
1) Remove the grip cover [A] (3 screws).
2) Loosen the screws of the magnet catches [B] (2 screws each).
3) Close the document feeder and tighten the screws of the magnet
catches when the rubber stopper [C] contacts the exposure glass.
19. Reinstall the grip cover (3 screws).
20. Remove the main PCB cover (1 screw), and set DIP SW 101 on the main
PCB as follows:
21. Plug in the copier and turn on the main switch.
22. Confirm the original registration. (See next page.)
23. Check the operation of the DF.
24. Position the original select switch to the thin paper mode (normal
position), and explain the function of this switch to the customer.
ON: 101 - 1
OFF: 101 - 2, 3, 4
28
20 December 1991
[B]