Ricoh A318 Service Manual page 38

31 October 1995
9.2 INSTALLATION PROCEDURE
[C]
CAUTION
Before installing the DF, check that the power cord is unplugged.
1. Remove the platen cover [A] (4 screws).
2. Remove the rear cover (4 screws) and the right cover (4 screws).
3. Secure the DF mounting bracket [B] (4 screws [12] in the accessories list).
4. Adjust the height of the DF mounting bracket in the following order:
1) Set the E plate [C] on the exposure glass as shown and measure the
clearance "a" between the DF mounting bracket and the E plate using
a scale.
2) If necessary, remove the DF mounting bracket and insert spacers [D]
until the clearance "a" is between 0 mm and 0.3 mm.
5. Remove the strip of tape [E].
[A]
[D]
A318503.wmf
"a"
A318I506.img
25
INSTALLATION PROCEDURE
[B]
A318I504.img
A318I505.img
[E]
A318I507.img
[D]