REPLACEMENT AND ADJUSTMENT
12.1.5 Pick-up Solenoid Adjustment
[A]
1. Turn off the main switch.
2. Place several sheets of paper [A] over the exposure glass area.
3. Lower the feed-in unit (see Feed-in Unit Removal) without disconnecting
the eight connectors.
4. Turn on the main switch.
NOTE: When the main switch is turned on, the DPS101 setting on the
DF main PCB must be as follows:
This is so that the initial check sequence can take place.
[D]
[C]
1 = ON
3 = OFF
2 = ON
4 = OFF
[B]
[F]
[E]
40
1 May 1993