1 May 1993
10.2 INSTALLATION PROCEDURE
[E]
[F]
[D]
1. Install the power supply unit (A110 copier only).
Refer to the installation procedure enclosed with the power supply unit
(A525).
2. Remove the following parts from the copier.
1) Platen cover [A] (2 push-locks)
2) Platen cover pedestal [B] (4 screws)
3) 2 screws [C] for fixing the operation panel
4) Rear cover [D] (4 screws)
3. Cut the two links [E] with nippers and bend the large harness cap [F] in
until it touches the rear cover.
4. Remove the lift sensor [G] (1 screw) (A111 copier only).
5. Remove the CC/G/B power pack [H] (1 screw and 2 locking supports)
and clamp the connector [I] as shown in the illustration; then reinstall the
CC/G/B power pack (A111 copier only).
INSTALLATION PROCEDURE (for Machine Code: A110/A111)
[A]
[B]
27
[C]
[I]
[H]
[G]