Ricoh A318 Service Manual page 53

20 December 1991
8.2 INSTALLATION PROCEDURE (for Machine Code: A072)
[A]
[C]
[D]
CAUTION: When installing the DF, make sure that the copier is
1. Remove the following parts of the copier.
1) Plate cover [A] (2 push-locks)
NOTE: Use a minus (slotted) screw driver to lift up the leaf spring [B] as
2) Two screws [C] fixing the platen cover
3) Two screws [D] fixing the scale cover
4) Harness hole mylar [E]
5) Right cover [F] (2 screws)
2. Open the rear cover [G] (2 screws).
3. Remove the strips of tape [H].
4. Remove the platen cover position sensor [I] (1 screw, 1 connector), then,
insert the removed connector into the bracket hole.
INSTALLATION PROCEDURE (for Machine Code: A072)
[B]
[H]
unplugged.
shown.
[E]
[G]
[F]
23
[I]