Replacing Fuses; Servicing The Traction Interlock Switch - Toro Greensmaster eFlex 2120 Series Operator's Manual

Replacing Fuses

If the machine does not turn on, even after charging,
check the machine fuses as follows:
1. Turn off the machine and disconnect the battery
pack.
2. Remove the 2 rear screws from the electrical
box, loosen the 2 upper screws, and remove the
box cover (Figure
Figure 41
1. Electrical box
2. Upper screws
3. Check the fuses in the fuse block
Figure 42
1. Fuse (30 A)
2. Fuse (3 A)
•
If any fuse is blown, replace them with a fuse
of the appropriate voltage and amperage
(Figure 42).
41).
3. Rear screws
(Figure
3. Open slot
Important:
rated for 80 V. Do not use 12 V automotive
fuses.
•
If the fuses are not blown, check the battery
pack fuse as follows:
A.
B.
g017423
1. Fuse cover
C.
42).
D.
E.
Servicing the Traction
g017424
Interlock Switch
Use the following procedure if the traction-interlock
switch needs adjustment or replacement.
1. Turn off the machine and disconnect the battery
pack.
2. Remove the control panel.
3. Engage the traction lever.
36
All fuses on the machine are
Raise the battery platform; refer to
Installing the Battery Pack (page
Remove the fuse cover
Figure 43
Check the fuse and replace it if it is
blown. Use only a Toro fuse (Part
No. 119-1208) to replace this fuse.
This fuse is specially designed for the
battery pack. Other fuses may cause
irreversible damage to the pack.
Replace and secure the fuse cover.
Torque the cover screw to 0.34 N∙m (3
in-lb).
Lower and secure the battery platform.
5
11).
(Figure 43).
g017425