Speed Control; Key Switch - Toro Greensmaster eFlex 2120 Series Operator's Manual

Figure 25
1. Parking-brake latch
Parking-Brake Latch
Use the parking-brake latch
service brake. Rotate the parking-brake latch toward
the brake handle to hold the service brake in place.
Pull the brake lever to release.
Note:
You cannot move the traction-control lever
while the latch is engaged.
Operator-Presence Control (OPC)
You must engage the operator-presence control
(Figure 24) before you engage the traction lever. If you
release the OPC during operation, the traction lever
returns to neutral and the engine continues to run.
InfoCenter LCD Display
The InfoCenter LCD display shows information about
your machine and battery pack, such as the current
battery charge, speed, diagnostics information, and
more (Figure 24).
For more information, refer to
LCD Display (page 27).

Key Switch

The key switch (Figure
and . With the brake off and the traction drive
START
disengaged, move the switch to the
until the InfoCenter display lights up, then release it
to the R position. Turn it to the O
UN
remove the key to turn off the machine.
2. Service brake
(Figure 25) with the
Using the InfoCenter
24) has 3 positions:
OFF
position
START
position and
FF

Speed Control

The speed control
on the right, rear side of the control panel. Rotate the
throttle to regulate the engine speed.
g016853
1. F position
AST
, ,
RUN
18
(Figure 24 and Figure 26) is located
Figure 26
2. S position
LOW
g027738