Installing The Cutting Unit To The Traction; Installing The Handle Retainers - Toro Greensmaster eFlex 2120 Series Operator's Manual

3
Installing the Cutting Unit
to the Traction Unit
Parts needed for this procedure:
2 Bolt (3/8 x 3/4 inch)
Procedure
Note:
To install the weight rod onto your machine,
refer to the installation instructions in your cutting unit
Operator's Manual.
1. Place the mower on its drums on a level surface.
2. Lower the kickstand and push in the locking pin
to lock the kickstand in the S
(Figure 6). Allow the machine to rest on the
locked kickstand.
Note:
Place the kickstand in the S
position whenever you remove the cutting unit.
This kickstand position keeps the machine from
tipping backward onto the handle.
1. Kickstand—S
TORAGE
position
2. Locking pin
3. Push the cutting unit under the traction unit and
to the left to engage the transmission coupling
(Figure 7).
position
ERVICE
ERVICE
Figure 6
3. Kickstand—S
ERVICE
position
1. Transmission coupling
4. Maneuver the machine frame forward until it
engages the cutting unit pivot arms
1. Telescoping coupler
2. Cutting-unit hex shaft
5. Secure the machine frame to the cutting unit
pivot arms with the 2 bolts (3/8 x 3/4 inch)
(Figure 8).
6. Move the kickstand to the S
by releasing the locking pin and allowing the
kickstand to rotate up.
g017356
7. Set the cutting-unit height of cut; refer to your
cutting unit Operator's Manual.
10
Figure 7
Figure
Figure 8
3. Bolt
position
TORAGE
g000483
8.
g017242