Toro Greensmaster eFlex 2120 Series Operator's Manual page 13

and then install the battery pack. Remove
the main power supply connector
from the battery base. Install the connector to
the battery as described. Install the battery to
the base, threading the attached wire harness
through the appropriate hole, and then secure
the main power supply connector to the battery
base with the fasteners that you previously
removed.
11. Remove the screwdriver holding the battery
base in the up position, and gently lower the
battery platform to the machine frame.
Important:
Do not pinch the wire harness
between the frame and platform.
12. Secure the battery platform to the machine
frame with the tall nut removed in step 4.
13. Tighten the pivot fasteners loosened in step 5.
14. Route the pack to machine wire harness under
and behind the main harness on the left side
of the machine and connect the small 6-pin
connector on the harness to the matching
connector on the main wire harness as shown
in Figure 15.
1. Connector—main wire
harness
15. Turn on and turn off the machine to ensure that
the battery charges completely.
16. Connect the T-handle connector from the
main wire harness to the main power supply
connector on the battery base
(Figure
Figure 15
2. Small connector—battery
pack
(Figure 16).
16)
1. T-handle connector
17. Charge the battery; refer to the lithium battery
charger Operator's Manual.
Note:
charge (approximately 40%). This is enough
charge for you to perform functional checks
on the machine and move it as necessary to
complete setup, but you should fully charge the
battery before you use the machine.
g017235
13
Figure 16
2. Main power supply
connector on the battery
platform
The battery is shipped with a partial
g017237