Adjusting The Ez-Turn Sensor; Installing The Transport Wheels - Toro Greensmaster eFlex 2120 Series Operator's Manual

6
Adjusting the EZ-Turn
Sensor
No Parts Required
Procedure
1. Ensure that the machine is on a flat, level
surface with the traction drum on the ground.
2. Loosen the jam nuts on the sensor and adjust
the sensor so that 1 thread is visible past the
lower jam nut (Figure
Figure 17
1. Sensor light (on top)
2. Jam nuts
3. EZ-Turn sensor
4. Roller
3. Tighten the jam nuts to secure the sensor.
4. Place a 3.8 cm (1-1/2 inches) block under the
front cutting unit roller
5. Loosen the fasteners that secure the sensor
bracket to the frame
6. Start the machine; refer to
(page 26).
17).
5. 3.8 cm (1-1/2 inches) block
6. Target plate
7. Bracket fasteners
8. Sensor bracket
(Figure 17).
(Figure 17).
Starting the Machine
7. Set the EZ-Turn switch to the O
8. Rotate the sensor bracket toward the target plate
until the light on top of the sensor illuminates
(Figure 17). If the light was already illuminated,
rotate it away from the target plate until it goes
out and then reverse direction until it illuminates
again.
9. Tighten the bracket fasteners.
10. Remove the block from under the roller and
place the machine on the kickstand.
11. Ensure that the target plate does not contact the
grass shield.
Note:
If the plate does contact the shield,
loosen the bracket fasteners and rotate the
switch up until the plate is no longer touching
the shield.
12. Turn off the machine.
7
Installing the Transport
Wheels
Optional
Parts needed for this procedure:
Transport wheels—Transport Wheel Kit (Model No.
2
04123 [Optional])
Procedure
1. Use your foot to push the center of the kickstand
down and pull up on the lower handle support
until the kickstand has rotated forward and over
center (Figure
g017357
1. Kickstand
14
position.
N
18).
Figure 18
g017244