Transporting The Machine To A Job Site; During Operation; During Operation Safety - Toro Greensmaster eFlex 2120 Series Operator's Manual

3. With the machine on, engage the parking-brake
latch, press the OPC, and engage the traction
lever (Figure 23
should not run and you should get an advisory
on the InfoCenter panel. If not, the interlock
switch needs service. Correct the problem
before operating the machine; refer to
the Brake-Interlock Switch (page
4. Turn off the machine and return the traction
lever to the N
EUTRAL
5. Carefully lower the machine off the kickstand.
Transporting the Machine
to a Job Site
Transporting the Machine a Short
Distance
Use the transport wheels to transport the machine a
shorter distance.
1. Install the transport wheels; refer to
the Transport Wheels (page 14)
2. Ensure that the traction and reel-drive lever is in
the N position.
EUTRAL
3. Ensure that the speed control is set to Z
4. Start the machine; refer to
(page 26)
5. Tip the front of the machine up, gradually move
the traction control to the F
and use the speed control to slowly increase the
machine speed.
6. Adjust the speed control to operate the mower
at the desired ground speed and transport the
machine to the desired destination.
Transporting the Machine a
Considerable Distance
Use a trailer to transport the machine a considerable
distance. Use caution while loading and unloading the
machine onto the trailer.
1. Carefully drive the machine onto the trailer.
2. Shut off the machine, engage the service brake,
and use the parking-brake latch to hold the
service brake in place.
3. Securely fasten the machine to the trailer.
Note:
You can use the Toro Trans Pro trailer to
transport the machine. For instructions on loading the
trailer, refer to your trailer Operator's Manual.
Important:
Ensure that the machine is shut off
while you transport it on a trailer, as damage
and Figure 24). The motor
Servicing
37).
position.
7 Installing
Starting the Machine
position,
ORWARD
can occur to the machine if it is on during
transportation.

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; long pants; slip-resistant, substantial
footwear; and hearing protection. Tie back long
hair, secure loose clothing, and do not wear loose
jewelry.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs. Keep
bystanders, especially small children, out of the
operating area. Shut off the machine if anyone
.
ERO
enters the area.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lightning.
•
Before you start the machine, disengage all
blade-attachment clutches, shift into neutral, and
engage the parking brake.
•
Watch for holes, ruts, bumps, rocks, or other
hidden objects. Uneven terrain could cause a
slip-and-fall accident.
•
Use extreme care when approaching blind
corners, shrubs, trees, or other objects that may
block your view.
•
Always stand in the operating position (behind the
handle) when starting and operating the machine.
•
Ensure that the grass basket is in place while
mowing. Shut off the machine before emptying
the basket.
•
Never leave a running machine unattended.
•
Do not tip the machine more than 25°.
•
Shut off the machine, disengage the drive to the
cutting unit, and remove the key in the following
situations:
– Before fueling
– Before clearing blockages
– Before removing the grass basket
25